Tuff Coat Australia

Polyurethanes Tuff Timber Coat Krystal Clear Tuff Coat for Concrete Tuff - Enviro TOP Finish Tung Oil Polyurethane Tuff H2O for Concrete Tuff Coat For Concrete UV Stable Tuff Sports Coat Supplementary Tuff Satin Finish Tuff Cleaning Solvent Rejection Eliminator Thinners Wet Edge Extender Anti-Rejection Free Flo Catalyst Satin Additive Product Slippery Test Results

Tuff Sports Coat

Comes in two forms solvent base where a strong durable Mid gloss Mid build finish is required outlasting all its competitors. In most cases 2 coats will be sufficient to make your recreational facility come to life. Save time and money with a coating that is built to last.

The Water Bourne finish is just as strong and durable as the solvent finish, this coating is a single base water borne finish which has no harmful solvents and no odours, therefore environmentally friendly.

Things You Need to Know About Tuff Sports Coat Solvent Base

Tuff Sports Coat can be used on all timber and cork surfaces.
Coverage is 10-14 sq.m per litre (depending on timber and timber preparation).
This product cannot be applied in temperatures below 10 degrees and above 32 degrees.
Due to its chemical adhesion capabilities Tuff Sports Coat will stick to most timber and cork surfaces.
Can be applied at 2-3 coats per day if the product is catalysed. This enables the drying time to be shortened to1-1.5 hours. (depending on atmospheric change will also shorten or extend they drying time.)
A 6mm-12mm Roller, However, we recommend that you use a roller that is between 6-12mm. It can be:

Lambswool
Mohair
Micro-Fibre

A brush can be used to cut in the edges.

Things You Need to Know About Tuff Sports Coat (Water-bourne)

Tuff Sports Coat can be used on all timber surfaces.
Coverage is 12-14 sq.m per litre (depending on timber and timber preparation).
This product cannot be applied in temperatures below 10 degrees and above 32 degrees.
There is a sealer that can be used under Tuff Enviro to give fantastic build.
Tuff Sports Coat should be applied from a bucket not a painters tray.
Tuff Sports Coat requires you to use either an applicator or a roller. However, we advise you to use a lambswool applicator 10-12mm as it is easier to rub in the first coat with an applicator.
Preparation is of outmost importance when applying any water base.

Floor Preparation

New Floors: Sand to a smooth finish (Not more than 150 grit), Make sure that the surface is clean, dry and free from wax, grease and dust. It is important that you vacuum thoroughly and then wipe the floor with either a wet tacky mop or a wet towel to make absolutely certain that there is no dust left on the floor. (please note to take extra care on the preparation for water-bourne)

Recoating an existing Floor: To ensure good adhesion to the old surface, wash the floor with Tuff Cleaning solvent, when floor is dry, sand the surface thoroughly to ensure that there are no contaminants on the surface, and then apply 2 or 3 coats of Tuff Sports coat(water-bourne (Don’t forget to sand between coats)). However, only 1 coat is required of the solvent based product for a good recoat.

Safe Handling (This only applies to the solvent base product)

Handling and usage of this product must be carried out under well ventilated conditions that prevent inhalation of Asthmatics take extra care. Prevent skin contact by wearing impervious gloves. Breathing of vapours is harmful and may cause lung irritation and allergic respiratory reaction irritates skin and eyes. This product must be kept firmly lidded as it deteriorates rapidly upon container immediately. In case of spillage, absorb into dry sand or earth. Remove from work area. Cover with water for 24 hours before disposal.

PRODUCT WARRANTY

In the interests of achieving a better product through research and improvements in manufacturing processes, Tuff Coat Australia reserves the right to change specifications without notice. Since Tuff Coat Australia has no control over product application, buyers and users must make their own assessment of our products under their own conditions to meet their own requirements. NO RESPONSIBILITY IS ACCEPTED, EXCEPT FOR THOSE NO-EXCLUDABLE CONDITIONS OF ANY TERRITORY, STATE OR FEDERAL LAW. Tuff Coat Australia’s liability is limited at its discretion to the replacement of this product or to the supply of equivalent product or to the refund of the original purchase cost of this product only from Tuff Coat Australia