Tuff Coat Australia

Polyurethanes Tuff Timber Coat Krystal Clear Tuff Coat for Concrete Tuff - Enviro TOP Finish Tung Oil Polyurethane Tuff H2O for Concrete Tuff Coat For Concrete UV Stable Tuff Sports Coat Supplementary Tuff Satin Finish Tuff Cleaning Solvent Rejection Eliminator Thinners Wet Edge Extender Anti-Rejection Free Flo Catalyst Satin Additive Product Slippery Test Results

Tuff Enviro

TUFF ENVIRO is a water borne polyurethane, which contains no harmful solvents. It is also non toxic with no noxious odours. Tuff Enviro is highly suitable when a heavy duty, long wearing gloss finish is required for cork or timber.

Advantages Are

Easy application
Gloss or satin finish
No bleaching of timber
Excellent chemical resistance
High durability
Appearance of finish very similar to solvent based products
High flexibility and scratch resistance
Non-yellowing on timber
No solvents no odours
Excellent adhesion to timber & between coats
Higher build coat than any other water based finish
EXTREMELY Low voc’s

Things You Need to Know About Tuff Enviro

Tuff Enviro can be used on all timber surfaces.
Coverage is 12-14 sq.m per litre (depending on timber and timber preparation).
This product can not be applied in temperatures below 10 degrees and above 32 degrees.
There is a sealer that can be used under Tuff Enviro to give fantastic build.
Tuff Enviro should be applied from a bucket not a painters tray.
Tuff Enviro requires you to use either an applicator or a roller. However, we advise you to use a lambswool applicator 10-12mm as it is easier to rub in the first coat with an applicator.
Preparation is of outmost importance when applying any water base.

Floor Preparation

New Floors: Sand to a smooth finish (Not more than 150 grit), Make sure that the surface is clean, dry and free from wax, grease and dust. It is important that you vacuum thoroughly and then wipe the floor with either a wet tacky mop or a wet towel to make absolutely certain that there is no dust left on the floor.

Recoating an existing Floor: To ensure good adhesion to the old surface, wash the floor with Tuff Cleaning solvent, when floor is dry, sand the surface thoroughly to ensure that there are no contaminants on the surface, and then apply 2 or 3 coats of Tuff Enviro (Don’t forget to sand between coats)

PRODUCT WARRANTY

In the interests of achieving a better product through research and improvements in manufacturing processes, Tuff Coat Australia reserves the right to change specifications without notice. Since Tuff Coat Australia has no control over product application, buyers and users must make their own assessment of our products under their own conditions to meet their own requirements. NO RESPONSIBILITY IS ACCEPTED, EXCEPT FOR THOSE NO-EXCLUDABLE CONDITIONS OF ANY TERRITORY, STATE OR FEDERAL LAW. Tuff Coat Australia’s liability is limited at its discretion to the replacement of this product or to the supply of equivalent product or to the refund of the original purchase cost of this product only from Tuff Coat Australia